So, you splashed grease on your favorite white shirt.

Soak the fabric overnight, then toss it in the dryer in the morning. Mix together 1 teaspoon of the concentrate, 1 scoop of oxygen-based cleaning powder, and water. If the deodorant stain remains despite the above method, time to use a concentrate combined with an oxygen-based cleaning powder. Let your white shirt sit for 2 hours, then launder in a washing machine using cold water. Mix well.Īpply the mixture on the armpit stains, then agitate. Then pour in ½ cup of hydrogen peroxide and two tablespoons of baking soda. Prepare 1 teaspoon of cleaning concentrate and a quarter cup of water. Although some deodorant stains can be permanent, you can still try to fix this discoloration issue by following the solutions below. Most deodorants contain aluminum, which is the ingredient that causes yellow stains in the armpits. It won’t damage it.īlot generous amounts of hydrogen peroxide onto the stain. This method will bleach your white shirt - but don’t worry. If the vinegar trick didn’t work, it’s time to resort to hydrogen peroxide. Soak your sweat-stained white fabric in the tub for 30 minutes. In a big enough tub, mix that cup of white vinegar with 2 cups of warm water (not boiling). If the hot-water laundering did not do the trick on your tough stains, try white vinegar. Simply launder the white fabric with your favorite laundry detergent - but use hot water instead. Sweat stains should be easy to remove from your white clothes. Dishwashing Detergent and Hydrogen Peroxideįorgot your antiperspirant or undershirt today? Or maybe you just had a big meeting or a big date! Don’t let those embarrassing stains on your white shirts stick around.įollow these instructions to wash your white shirt, ideally before the sweat dries.Avoid alcohols, ketones such as acetone, and nail polish removers. Keep it away from ignition sources, use with adequate ventilation, and follow the manufacturer’s instructions. A combustible liquid, it is a distillate of petroleum and has a mild odor similar to kerosene. * Mineral spirits is a clear water white solvent sold in hardware and paint stores, often as paint thinner for oil-based paints. If odor is a problem, wash out the mineral spirits with soapy water or a dilute solution of Woolite or a mild dishwashing liquid. If necessary, lightly scrape the last of the White-Out from the valleys of the leather grain with fingernails.

In the final cleaning, use a new, clean cloth to avoid re-transferring the White-Out.Several cleanings may be necessary to remove all of the White Out and to avoid a hazy or chalky appearance on the NYTEK® surface once the solvent has evaporated. Blot it up quickly with a clean, dry soft cloth to avoid spreading.The White Out will fade as it begins to dissolve. Dip a soft toothbrush into mineral spirits,* shake off the excess, and brush the remainder of the stain in a circular motion.Work with a small area or one spot at a time.Repeat three or four times until White Out no longer transfers to the tape. Push the tape down into the grain with the wooden handle of a kitchen utensil. Rub masking tape on the dried spot, pulling it off quickly. If the White Out is still wet, blot it with a cloth, sponge or paper towel. Wite-Out®, Liquid Paper® or Similar Correction FluidsĬorrection fluids will dry in one to two minutes, so quick action is necessary.

Removing white out